These products are the most recommended by Stellram for Milling
applications.
Grade
SP6564
Stellram
now offers a new grade for machining stainless steels. The
combination of a lubricant layer and super hard coating provides
a low coefficient of friction and at the same time gives reliable
protection against wear. The sharper cutting edge reduces
the built-up edge damage and gives the work pieces an excellent
surface finish. SP6564 can be run in dry machining applications.
This new grade is available across a wide range of milling
inserts.
7745
VSE Series
High
positive designed for stainless steels and high temperature
alloys. Square inserts with a 15° clearance are used for reducing
edge build-up in these tough materials.
Stellram
now offers a new grade for machining stainless steels. The
combination of a lubricant layer and super hard coating provides
a low coefficient of friction and at the same time gives reliable
protection against wear. The sharper cutting edge reduces
the built-up edge damage and gives the work pieces an excellent
surface finish. SP6564 can be run in dry machining applications.
This new grade is available across a wide range of milling
inserts. 
High
positive designed for stainless steels and high temperature
alloys. Square inserts with a 15° clearance are used for reducing
edge build-up in these tough materials.
Case Study - 
